#1
17th Dec 2009 at 10:31 PM
Last edited by a31cefiro : 17th Dec 2009 at
11:04 PM.
Reason: Added in pictures.
Diagonal walls + rooves = NO GOOD!
Hey everyone, I hope I've posted this in the right section.
Yesterday I tried making a house in TS3. "Oh cool!" I thought, when I saw diagonal rooms/walls. I made a two story house where the bottom story was a large rectangle with a diagonal square coming off one side. I then made the second story a small rectangle.
It all goes well, then I remember I have to stick a roof on, and that's when it failed
. The roof looked crazy! It had so many apexs, jagged bits, bits going all over the show. I was really disapointed. I couldn't even put on a roof manually, it would jut into the second story rooms (even though they had a floor).
I don't have any screenshots but I could take some if needed to show what I mean.
Is the only way to have a roof on an oddly shaped building, is to have a flat one?